Main Unit of V4.94 Digiprog III Digiprog 3 Odometer Programmer with OBD2 Cable


 
Digiprog3 V4.94 Update Note:
 
1. Make sure the power connect is ok and the power supply is enough and stable. 

make-sure-the-power-connect-is-ok
 
2. Donot enter standby mode, or the computer screen display as in protection state.
3. Donot cut off the power during the digiprog3 update process.
4. Operation Windows System must be Winxp sp3 32bit, close the antivirus and firewall software in advance. 
5. Make sure the device serial number match with the sn of the Digiprog Update file, and check if there are Digi1.bin and Digi2.bin in the update file before start.

make-sure-digiprog3-serial-number-match-the-digiprog-update-file

6. Make sure select the Digi1.bin file during update process.


How to update Digiprog3 V4.94 ?

 
1. Connect the USB cable to the computer, start your dp3, run Digiloader1.exe.

digiprog3-4_94-update-notice

connect-usb-cable-to-the-computer-2

connect-usb-cable-to-the-computer-4

 
2. Choose the right port, select Digi1.bin, Click the button. If your dp3 dose not enter blue screen,check your setting and restart from step 1.

digiprog3-4_94-update-notice-select-digi1bin-file

digiprog3-4_94-update-display-bluescreen
 
3. In upgrading, it should be like this until over.  Attention, it will be damaged if you remove it now.
 
4. Upgrade Over. Your dp3 should restart automatically.

digiprog3-update-ok-to-restart